Modular Steel Roof Tile Roll Forming Machine

Modular Steel Roof Tile Roll Forming Machine

1. Components for the modular steel roof tile roll forming machine

The roll forming machine includes manual uncoiler unit, sheet guiding equipment, roll forming system, cutting equipment, hydraulic station, electric controlling system and run out supporting table.

2. Technical Parameters

Material specification Aluminum, alu-zinc, galvanized and pre-painted galvanized steel.
Thickness 0.3-0.7mm.(perfect is 0.4mm-0.6mm)
Main motor power 5.5 kw.
Hydraulic station power 5.5kw.
Feeding width 1250mm.
Cover width 1100mm
Yield stress 235Mpa (33KSI) ~ 345Mpa (50KSI).
Roll forming Speed 15-18 m/min
Cutting Tolerance +/-2.5mm(length≤5000mm); +/-3.0mm(5000mm<length≤10000mm).
Manual Uncoiler Max. Capacity: 5000kgs.
Coil inner diameter 508mm.
Voltage 380V,3 Phase,50HZ,Or As per customer’s request.
Numbers of stands 15 stations
Type of cutting Roll-formed and length-set profile cutting.

Steel roof roll forming machine1 - Modular Steel Roof Tile Roll Forming Machine

3. Material of Main Equipment:

Roller Material High grade S45C forged steel, coated with hard chrome.
Active Shaft Material High grade S45C carbon wrought steel, diameter 76mm.
Electric Elements PLC control console, touch screen and transducer, from Siemens, Germany.
Other elements, from Schneider Electric, Germany.
Cutter Blades Cr12MoV steel with quenched treatment, hardness HRC58~61,
wear-resistance, good steel structure, long life.

Process Sketch:

Uncoiling →Infeed guiding →Roll forming →Pressing→Measure Length&Shearing →Sheet to Support Table
Packaging & Shipping
1.One 20ft container for loading one set machine with manual decoiler;
2.The whole Wiped Anti Rust Oil, PLC controller covered by foam film;
3.Spare parts and some small parts packed in plastic tooling box;
4.All Components Fixed by steel wire with Container.

Leave a Reply

Your email address will not be published. Required fields are marked *