Composite plate machine can generate the following conditions during use

Composite plate machine can generate the following conditions during use

(1) Composite board machine start the machine idle for several cycles, ensuring to cut sheet metal of different thickness, from thin to thick under normal circumstances. Ensure that the users are familiar with composite board machine performance.

(2) It must be adjusted different blade clearance when doing different thickness shear test. If the corresponding blade gap doesn’t adjustment, the impact of the blade will durability.

(3) Composite panel is turned on in the shearing process gauge switch, observe oil pressure value, when cutting a 12 mm plate, the pressure should be less than 20 MPa. This remote relief valve No.9, factory pressure settings 20-22 MPa, the user must comply with this requirement, must not increase the pressure to cut surface material exceed a predetermined, resulting in damage to the machine.

(4) Keep the sound balance when operating. If the composite board machine has noise, you should stop and check it.

(5) When operating the composite panels, the temperature of tank must raise less than 60 degrees, if it goes beyond the limit, you should close it done to let it rest.

imagestore20150822e5fbdd25 a996 4e6e 9a68 7c234a3c4299 300x168 - Composite plate machine can generate the following conditions during use

Leave a Reply

Your email address will not be published. Required fields are marked *