Automatic steel tile tile press board deviation how to do
Color steel tile press equipment will inevitably occur in the production process one way or another, the most common problem is the color plate deviation, in the event of deviation will affect production efficiency and product qualification rate of machines, so we must to know how to correct these errors, after a long period of research, exploration, we have come to rectify this issue: If the device board to the right side, then run, you need iron to the corner of the pad left or right side of the roll axis flatten, the first of several shaft axis deviation took the first of several flattened above and below the roller roller should be consistent, if the above flattened, then the following should also be flattened, symmetrical roller can not change of. If not enough, on the first colored steel tile machine before the machine, after two rows of four corners of the frame and the like from the big adjustment in the end highly consistent position on the shaft end, and then discharged to the last row from the first, to find a line straightened, check whether the lower shaft in a horizontal line, the lower shaft left and right sides into a level. Steel tile equipment in the first row and the last row to find a good point of symmetry, then tighten lock nut on both sides, before the middle of the center of the wheel, after a good pull a straight line, the upper and the lower shaft of the gap adjusted, it You can adjust the machine along a straight line. In fact remedy plate deviation is we need long-term production and testing of different deviation direction has a different remedy, but one thing to note is that whether it is mechanical roller or other parts are needed on both sides of the alignment, only two sides aligned in order to maintain symmetry, the shape of the production will be structured.